Roland R-1000 Manual de servicio descargar pdf (Pagina 105)

Manual

Double Sheet Detector R1000 series E20

B0046991 / Rev. 1.6

Start-up

ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33

105

7.6 Program parameters

The program parameters contain the information required for the various measurement programs.

For accessing the program parameters, select the mode “configuration program parameter“ and

confirm with ENTER.

Program parameter 1: Selecting the measuring program to be configured.

Fig. 43: Selecting the program to be configured

Here the measuring program (1-255) to be configured is selected. All following adjustments apply

to the selected program (here: program no. 1).

Program parameter 2: Selecting the sensor to be used for measurement (only for 4P version).

Fig. 44: Selecting the sensor

Here the sensor (1 - 4) must be selected, which is to be used for measurement (4P version only).

For this purpose the item "program" must be selected under “sensor selection“ in the system

configuration.

If the sensor selection is made via "program" the sequence measurements are also available.

Thus the following combinations are available:

• 1 / 2 / 3 / 4 / 1+2 / 1+3 / 1+4 / 2+3 / 2+4 / 3+4 / 1+2+3 / 1+2+4 / 1+3+4 / 2+3+4 / 1+2+3+4

Program parameter 3: Specifying the nominal thickness of the sheet to be measured.

Fig. 45: Adjusting the nominal thickness

Here the nominal thickness of the sheet to be measured is specified. Normally, the nominal

thickness is the sheet thickness used for teach-in.

Note A change of the nominal thickness deletes the values determined

during teach-in. A new teach-in is required.

program par. 1

program no.: 1

program par. 2

sensor: 1

program par. 3

nom.thick.0.90mm

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 135 136

Sin comentarios

Roland R-1000 Manual de servicio Pagina 105