Roland TD-10 Manual de usuario Pagina 92

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 182
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 91
Customizing the tone (Equalizer)
Here you can adjust the high and low frequencies balance
for the instrument assigned to each pad. (TRIGGERS 1-10
only)
* This setting is not available for the AUX1,2 trigger inputs.
fig.06-06
Procedure
1. Press [CONTROL ROOM]-[F3 (EQ)].
The “EQ” page will appear.
2. Strike the pad that you wish to edit.
The setting page for the pad you struck will appear.
3. Use [CURSOR] to move the cursor to the parameter that
you wish to set.
4. Use [INC/DEC] or the VALUE dial to make the setting.
In this page, [F1] will turn the equalizer on/off. Pressing [F3]
or [F4] will move the cursor directly to the low range (LOW)
or high range (HIGH) settings.
Parameters
TYPE: Peak, L shelv, H shelv
Peak: The vicinity of the specified frequency range will be
boosted/cut.
L shelv: The entire range below the specified frequency will
be boosted/cut.
H shelv: The entire range above the specified frequency will
be boosted/cut.
Q: 0.5, 1.020, 1.0 steps
Adjusts the width of the frequency range that will be boost-
ed/cut. For example, when the “Q” value is small, raising or
lowering the low range “GAIN” will affect a broad area
extending close to the high range.
FREQ (Frequency): 2020 kHz
Adjusts the point at which the boost/cut will occur.If you
wish to boost/cut a range that is higher than the current
range, you would adjust this setting.
GAIN: -150+15 dB
Adjusts the amount of the boost/cut. Negative (-) settings
produce a cut.
GAIN
Frequence
FREQ
HShelvLShelv
Peak
Q
0
0
Chapter 5. Control room settings
92
Vista de pagina 91
1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 181 182

Comentarios a estos manuales

Sin comentarios