Roland CAMM-2 PNC-2300 Manual de usuario descargar pdf (Pagina 20)

Part 1

8. Setting the Origin (Home Position)

The home position is the point that becomes the origin point in the X and Y directions. Usually, this point is set at the front left corner of

the fixed workpiece. The setting method explained here, uses the left, bottom corner (nearest the operator) of the workpiece as the home

position.

The home position points are registered in the PNC-2300 memory right after power is turned on and before power is turned off.

Press the [MENU] key to make the following screen

appear on the display.

Press the [ENTER] key to make the following screen

appear on the display.

Press the [ ] key to move the blinking cursor (“ ”) to

“XY-Axis,” then press the [ENTER] key.

Press the arrow keys and the CUTTER UP/DOWN

keys to move the cutter with the front left corner of

the workpiece.

Press the [ENTER] key.

Make sure that “< >” appers.

X axis

Y axis

Bottom of the head

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 54 55

Sin comentarios

Roland CAMM-2 PNC-2300 Manual de usuario Pagina 20