Roland INTEGRA-7 Editor Manual de usuario descargar pdf (Pagina 3)

Installation and Setup (Windows)

Installation Procedure

Use the following procedure to install INTEGRA-7 Editor Ver.2.

NOTE

INTEGRA-7 Editor Ver.2 is a 64-bit plug-in.

It cannot be installed in 32-bit versions of Windows.

In order to use INTEGRA-7 Editor Ver.2, you must install the USB driver. Download the USB

driver from the Roland website. For details, refer to Readme.htm found in the le that you

download.&http://www.roland.com/support/

In order to use INTEGRA-7 Editor Ver.2, you must set the INTEGRA-7’s own USB driver setting

to “VENDER.” Make this setting as described in “Using the INTEGRA-7 with a Computer” in the

INTEGRA-7 owner’s manual.

1. Download the INTEGRA-7 Editor Ver.2 installer from the Roland web-

site.

2. Decompress the le that you downloaded, and run “INTEGRA7EditorV-

er2_x64_en.msi.”

3. The “Welcome to the INTEGRA-7 Editor

Ver.2 Setup Wizard” dialog box appears.

Click [Next].

4. The “Select Installation Folder” dialog box appears.

Click [Next] to begin the installation.

5. The “Conrm Installation” dialog box appears.

Click [Next] to begin the installation.

If the “User Account Control” dialog box appears,

click [Yes].

6. The “Installation Complete” dialog box appears.

Click [Close] to exit.

Uninstallation Procedure

If you need to uninstall INTEGRA-7 Editor Ver.2, proceed as follows.

1. Run “INTEGRA7EditorVer2_x64_en.msi.”

2. The “Welcome to the INTEGRA-7 Editor Ver.2 Setup Wizard” dialog box

appears. Choose “Remove INTEGRA-7 Editor Ver.2” and then click [Fin-

ish].

If the “User Account Control” dialog box appears,

click [Yes].

3. The “Installation Complete” dialog box appears.

Click [Close] to exit.

1 2 3 4 5 6 7 8 9

Sin comentarios

Roland INTEGRA-7 Editor Manual de usuario Pagina 3