
Using Effects
Inserting the Same Effect into Another Track as
Well
If in step 7 you selected "Insert" or "Inserts," that effect cannot be inserted
into another channel / track. If you chose "InsertL" or "InsertR," that effect
can be inserted into only one other channel / track.
If You Wish to Use the Same Effect Both as Send/
Return and Insertion
It is not possible to use the same effect for both insertion and send/ return.
Even if the FXIns (Effect Insert Switch) parameter is set to except "Off," the
EFFECT (Effect Switch) parameter can be set to either "PreFade" or
"PstFade." This is because the VS-890 is able to send the signal of the FX bus
not only to the effect but also to another output jack.
For example if you insert FX2 into track 1, the FX2 bus will not be used (it
will be vacant). In this situation if you set the track 2 EFFECT2 to "PstFade,"
the track 2 signal will be sent to the FX2 bus, but it will not be sent to the
effect itself (FX2). Since the signal of the FX bus can be assigned to the
outputs Digital out 1/2, AUX out A/B, Master, and Monitor, you can make
settings so that the signal of each track is sent from separate outputs. In
other words if the effect (FX2) is inserted, you can use the unused FX bus
(FX2) as an AUX bus.
EQ
{2band, 3band)
,. Sw
Send
Level
FX2 Send
Pan
Sw Level
AUX Send
Pan
Sw
Level
MIX FX1 FX2 AUX
LR LRLRLR
MIX
Sw
I
I
I
I I I I
oi
Comentarios a estos manuales