Roland JUNO-Gi Manual de usuario descargar pdf (Pagina 14)

Turning the Power On

* Once the connections have been completed (p. 12), turn on power to

your various devices in the order speci ed. By turning on devices

in the wrong order, you risk causing malfunction and/or damage to

speakers and other devices.

1. Minimize the volume of the JUNO-Gi and your speakers.

2. On the JUNO-Gi’s rear panel, turn the [POWER] switch ON.

* Always make sure to have the volume level turned down before

switching on power. Even with the volume all the way down, you

may still hear some sound when the power is switched on, but this is

normal, and does not indicate a malfunction.

3. Turn on the power of your speakers.

4. Use the [VOLUME] knob to adjust the volume appropriately.

Turning the Power O

1. Minimize the volume of the JUNO-Gi and your speakers.

2. Turn o the power of your speakers.

3. Turn the JUNO-Gi’s [POWER] switch OFF.

If you don’t want the power to turn o automatically, turn o the “ Auto Power O ” setting

The JUNO-Gi will automatically turn o when no operation has been performed for a certain length of time. (With the factory settings, the power

will turn o after 240 minutes.)

NOTE

When the power turns o , any unsaved modi cations that you’ve made in the settings will be lost. If you want to keep the setting changes

you’ve made, make sure to save them beforehand.

If you want to leave the power on at all times, turn o the “Auto Power O ” setting as described below.

1. Press the [MENU] button.

2. Use the VALUE dial or the cursor buttons to select “4. System,” and then press the [ENTER] button.

3. Press the [1] (GENERAL) button.

4. Use the cursor buttons to select “Auto Power O .”

5. Use the VALUE dial to change the setting to the “OFF” setting.

6. Press the [6] (WRITE) button to save the setting.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 147 148

Sin comentarios

Roland JUNO-Gi Manual de usuario Pagina 14