Roland SPD-S Manual de usuario descargar pdf (Pagina 88)

Chapter 7 Changing the Setup (Overall Environment)

Wave Protect

This feature provides protection to sampled waves to prevent them from being lost by mistake.

The wave protect setting is remembered when the SPD-S is powered off. When you next power the SPD-S on, the SPD-S is booted

with the latest wave protect setting active.

Its factory setting is

(enabled).

Enabling the wave protect

When the wave protect is OFF (disabled), hold down [WAVE] and [SETUP], and power the SPD-S on.

After the indication "Welcome to SPD-S," "wave protect on" appears and the wave protect is set to ON

Disabling wave protect

When wave protect is ON (enabled), hold down [WAVE] and [SETUP], and power the SPD-S on.

After the indication "Welcome to SPD-S," "wave protect off" appears and wave protect is set to OFF.

When wave protect is ON, the following operations cannot be executed with a "wave protected!" message indicated.

• WAVE TRUNCATE and WAVE DELETE in Wave Edit

• BACKUP LOAD in Card Utilities

• DELETE ALL WAVES and DELETE ALL in Setup Edit

SPDS_e.book 88 ページ２００４年４月１９日　月曜日　午前９時５８分

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 143 144

Sin comentarios

Roland SPD-S Manual de usuario Pagina 88