Roland Stika STX-7 Guía de usuario descargar pdf (Pagina 10)

TUTORIAL 3 - Setting up the STIKA and cutting a sample

During the course of this tutorial you will create a simple text drawing and cut out the design.

1. Start up Stika Design. Choose Setup > Layout, ensure that the software is set to suit your par-

ticular model of STIKA, and note the material size values. Click OK to close the dialog box.

The drawing screen should now look something like the illustration below (it will vary accord-

ing to the model of STIKA chosen). You will notice a grey dotted rectangle inside the white

vinyl area - this is the actual cutting area of your STIKA.

2. Ensure that your STIKA is connected to the computer, is powered up, and a suitable piece of

vinyl (the size specified in the Layout dialog box) is inserted ready to cut. (For the STX-7,

load the material and ensure that the green light is on by pressing the button on the machine.

For the SCP-85, ensure that the picture LED is off, then insert the material and wait until it

has stopped feeding through.)

3. Choose the Linear text icon.

At the prompt Locate start position for text, move the cursor to a position approximately

10mm (1 grid space) to the right of the left edge of the grey dotted inner box, and 40mm (4

grid spaces) down from the top edge of the grey dotted inner box, then click the LH mouse

button. The following dialog box will open.

Page 8 DESIGN TOOLS - Stika Design

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Sin comentarios

Roland Stika STX-7 Guía de usuario Pagina 10