Roland SC-545EX Manual de usuario descargar pdf (Pagina 73)

Chapter 4: A Wide Variety of Operations

4-3 Setting the Location Where Printing Starts

Setting the Start Location

Load media and install a blade, then press the

[SETUP] key.

Use the arrow keys to align the blade with the

new printing or cutting start location.

Press the [BASE POINT] key.

The display in the figure appears.

To release the setting

The position setting by [BASE POINT] key is released such as the following.

• When printing, cutting, or printing and cutting for one page finish

• Press the [SETUP] key to cancel the setup for the media

When printing, do not use the [ ] key as much as possible to pulling back the media. Otherwise the following may occur.

• The pinch rollers may pass over the printed surface and smudge the ink.

• The grit rollers may leave tracks on the media, reducing printing accuracy.

• Printing may sag.

The center of the blade

The BASE POINT LED lights up

W 782 mm

When the Start Location Is Specified Using [ ] and [ ] Keys

When the operation is performed using only the [ ] and [ ] keys, the cutting carriage comes to a stop inside the cover.

Pressing the [BASE POINT] key while in this state sets just the start position for the feed direction (the direction of front-to-

back movement). For the scanning direction (the direction of carriage movement), the setting is made at the edge of the printing

area.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 134 135

Sin comentarios

Roland SC-545EX Manual de usuario Pagina 73