Roland Metaza MPX-80 Manual de usuario descargar pdf (Pagina 40)

3-2 Getting Ready

Chapter 3 Making Prints

If you’re performing printing with head cap used, this completes loading of the material.

If you’re performing printing with no head cap used, then go on to the following steps.

The procedure from this point on is for when you’re not using the head cap.



Press the Power/Movement but-

ton.

The head moves and stops at the position

where the tip of the head cap rides on the

surface of the material.



Loosen the knob.

Rotate the knob counterclockwise once.

Then you can move the stopper.

When material is too large to be placed within the table

Place the material in a way that the

center of the printing area comes to

the center of the scale on the table.

If the material tilts, place a support

in order to keep the material hori-

zontal.

Center

Line

Center Line

Material

Center of the

material

Adhesive

sheet

Stopper

Knob

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 119 120

Sin comentarios

Roland Metaza MPX-80 Manual de usuario Pagina 40