Roland Metaza MPX-80 Manual de usuario descargar pdf (Pagina 44)

3-2 Getting Ready

Chapter 3 Making Prints



Mount the center vise.

Fit the tabs on the bottom of the center

vise into the holes in the table on the

unit.

If the material tilts, place a support in

order to keep the material horizontal.

If you’re performing printing with head cap used, this completes loading of the material.

If you’re performing printing with no head cap used, then go on to the following steps.

The procedure from this point on is for when you’re not using the head cap.



Press the Power/Movement but-

ton.

The head moves and stops at the location

where the tip of the nose cap touches the

surface of the material.



Loosen the knob.

Rotate the knob counterclockwise once.

Then you can move the stopper.

Tab

Fit the tabs here in the case

of vertical mounting.

Fit the tabs here

in the case of hori-

zontal mounting.

Stopper

Knob

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 119 120

Sin comentarios

Roland Metaza MPX-80 Manual de usuario Pagina 44