Roland VS-2000 Guía de usuario descargar pdf (Pagina 170)

170

Chapter 13 Mastering

After Rec (after recording)

Specify the time location of the mastering track to which the

mixdown will be recorded. When creating an original audio

CD, it is usually best to select “to ZERO.”

to ZERO

:Place the data starting at 00h00m00s00f.

to last Phrs:0S

:Place the data after the end of the last

phrase in the mastering tracks.

to last Phrs:2S

:Place the data two seconds after the end

of the last phrase in the mastering tracks.

to last Phrs:4S

:Place the data four seconds after the end

of the last phrase in the mastering tracks.

Stay HERE

:Place the data at the time location at which it

was actually recorded.

fig.2-05.e

Marker

If this is turned “On,” a track number marker will

automatically be assigned to the beginning of the data that is

mixed down. Normally, you will set this “On.”

Hold down [STOP], and press the [STATUS] button for

all tracks (1–15/16) that you wish to mix down. The

STATUS indicators will light green.

fig.2-06

Press [FADER] so that the TR (track) indicator lights.

fig.2-07.e

Press [PLAY]. The song will play back.

Raise and lower the Master fader to set the overall

mixing volume.

The sound that passes through the Master fader will be

recorded on the mastering tracks. In order to record at the

optimal audio quality, you should normally set this to the 0

dB position.

Use the channel faders (1–15/16) to adjust the volume

balance of each track. At this time the sound that is being

output from the MASTER jacks—including volume

levels and panning—will be recorded to the mastering

tracks. It is best to set the volume as high as possible

without causing it to distort.

10.

When you have finished adjusting the volume, press

[STOP].

11.

Move to the location at which you wish to begin the

mixdown (such as 00h00m00s00f).

12.

Press [REC]. The REC indicator will light in red.

13.

Press [PLAY]. The PLAY indicator will light in green,

and recording will begin.

14.

When you finish recording, press [STOP].

Signal flow (routing)

fig.2-08

0 Time

Mixdown

Phrase

Original

Phrase

0 Time 0 Time

0 Time

to ZERO to LastPhrs:0s to LastPhrs:2s

to LastPhrs:0s Stay HERE

If “Can’t Set Marker” Appears in the

Display

CD markers must be set at least 4 seconds apart. If you

see this message, your markers are set too closely

together. To fix this, try a longer After Rec setting. You

can also reset the markers manually—see "CD Track

Numbers," p. 177.

Lit

Dark

TR1

MASTER

MIX

Track 1--16

TR15-16

TR16-16

Mastering

Track

MASTER OUT

MONITOR OUT

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 281 282

Comentarios a estos manuales

Sin comentarios

Roland VS-2000 Guía de usuario Pagina 170

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos musicales Roland VS-2000