Roland ep-5 Manual de servicio descargar pdf (Pagina 12)

– 12 –

8. Indicator adjustment

9. Cam adjustment

10. Dampers

To adjust the indicator, take off front cover and pull the indicator

upwards until it comes off the Allen screw.

Before installing the indicator make sure that the Allen screw is

tightened. Press the indicator on the screw and adjust it by rotating

clockwise to desired position.

With the cover and indicator removed, loosen the screw 1 and turn the

cam locking nut 2 counterclockwise until the cam loosens. Adjust the

cam 3 as desired making sure that the ball bearing 4 always is riding

on an active lobe on the cam. To secure the cam, make sure that screw

1 is backed out from the locking nut 2 then finger tighten the locking

nut and tighten screw 1. Install and adjust the indicator and reinstall

cover.

The standard built in dampers 5

located on the connecting block prov-

ide a simple means of adjusting the

actuator travel speed.

For maximum actuator travel speed

dampers shall be adjusted to mini-

mum damping position. (Fig).

Double acting actuators – adjust

only OUTLET damper, set SUPPLY

damper in minimum damping posi-

tion.

Single acting actuators – adjust both

dampers for desired operation.

correct

incorrect

1-2 mm (1/16")

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Sin comentarios

Roland ep-5 Manual de servicio Pagina 12