Roland MC-505 Manual de usuario descargar pdf (Pagina 2)

I. Synchronization

®ÂØÒÅÎ Supplemental Notes External Sequencing with the MC-505

When you are using the MC-505 with a sequencer or

drum machine, you will probably want to synchronize

the clocks of the two devices. The first decision you

need to make is which device will be the master.

Using the MC-505 to Control a Sequencer

If the MC-505 is set to be the master, you will control

playback of both devices from the Play, Stop, FF, and

RR buttons on the Groove Box. Use the following proce-

dure to make this setting:

1) Connect a MIDI cable from the MIDI OUT of the

MC-505 to the MIDI IN of the sequencer.

2) While holding SHIFT, press KEYPAD 11 (fig. 1).

3) Use the PAGE</> buttons to select Sync Out =.

4) Use the VALUE dial to select Sync Out = ON.

5) Press EXIT.

Using the MC-505 as a Slave to a Sequencer

Use the following procedure to set up the MC-505 to fol-

low the MIDI clock of a sequencer. In this type of setup

the sequencer will be used to start and stop the MC-505:

1) Connect a MIDI cable from the MIDI OUT of the

sequencer to the MIDI IN of the MC-505.

2) While holding SHIFT, press KEY PAD 11 (fig. 1).

3) Use the VALUE dial to select Sync Mode =

SLAVE, then press EXIT.

FFiigg..11

MMCC--550055 FFrroonntt PPaanneell

SSHHIIFFTT ++ KKEEYY PPAADD 1111

1 2 3 4 5 6 7 ... 10 11

Sin comentarios

Roland MC-505 Manual de usuario Pagina 2