Roland MC-505 Manual de usuario descargar pdf (Pagina 3)

II. Setup

®ÂØÒÅÎ Supplemental Notes External Sequencing with the MC-505

The next four sections will deal with using the MC-505

as a slave to an external MIDI sequencer. In this type of

setup you will normally be sequencing from a hardware

or computer-based sequencer. The MC-505 will be used

as a sound module with up to 8 MIDI channels available.

You can select sounds from your sequencer (section III)

and trigger the arpeggiator or the RPS function (section

IV). You can also control other aspects of your sound

from the sequencer using other types of MIDI messages

(section V).

You should first set the MC-505 to be a slave (see pre-

vious section Using the MC-505 as a Slave to a

Sequencer). The next step will be to select an empty

pattern. Use the following procedure:

1) Press PTN/SONG so it is lit and use the VALUE dial

to select U:001 EMPTY PATTERN. If U:001 is not

empty, use the VALUE dial to select a user pattern

that is empty.

Next you should check to make sure that the Remote

Keyboard Switch is OFF. If this switch is ON, you will

not be able to access different sounds on different MIDI

channels. You should also make sure that the MIDI

reception (Rx) switches are ON so your external

sequencer can properly control the MC-505. Use the fol-

lowing procedure:

1) While holding SHIFT press KEY PAD 12.

2) Use the VALUE dial to select Remote Kbd = OFF.

3) Use the PAGE </> buttons to select MIDI Rx SW.

4) Use the PART SELECT buttons and the VALUE dial

to set these all to + (On).

5) Press EXIT.

You are now ready to begin sequencing. There are eight

parts available in the MC-505 that are assigned to MIDI

channels as shown in figure 2.

Part

MIDI Channel

Part 1 Ch. 1

Part 2 Ch. 2

Part 3 Ch. 3

Part 4 Ch. 4

Part 5 Ch. 5

Part 6 Ch. 6

Part 7 Ch. 7

Rhythm Part Ch. 10

FFiigg..22

MMCC--550055 MMIIDDII cchhaannnneell

aassssiiggnnmmeennttss

1 2 3 4 5 6 7 8 9 10 11

Comentarios a estos manuales

Sin comentarios

Roland MC-505 Manual de usuario Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Mezcladores de audio Roland MC-505